Typical System Setup - Franklin Electric SUBMONITOR CONNECT Manuel D'installation Et D'utilisation

PRODUCT INFORMATION

Typical System Setup

Typical System Setup
Your system setup may vary from that shown.
1. SubMonitor Connect
2. External Pilot (HOA) Switch (external control switch)
3. Contactor (connection point between motor and starter)
4. Circuit Breaker (molded case type) or Terminal Block for Input Power
5. Voltage Input L1, L2, and L3 from Disconnect (power for the SubMonitor Connect)
6. Motor Wires from Disconnect to Contactor routed through SubMonitor Connect sensor tunnels
7. SubMonitor Connect remote display connection
8