Start-Up Programming; Using The Control Interface - Franklin Electric SUBMONITOR CONNECT Manuel D'installation Et D'utilisation

5. Connect each CT wire to it's other CT wire via the grounded terminal block (inset photo on previous
page).
CT Kits available:
• 5860015170 - SubMonitor Connect CT Kit, 120-270A
• 5860015180 - SubMonitor Connect CT Kit, 200-400A
• 5860015210 - SubMonitor Connect CT Kit, 320-720A
• 5860015190 - SubMonitor Connect CT Kit, 400-900A
When using CTs as part of the SubMonitor Connect system, be sure to program the SubMonitor Connect
appropriately. Refer to "Programming: Advanced Setup > Administration" on page 26
setup, or make this setting using the FE Connect mobile app.
An example for CT use:
An installation is using 500:5 ratio CTs with 500 A on the power lines.
The SubMonitor Connect measures 5 A. The SubMonitor Connect resolution is 0.1 A, which equates to ±10 A
reading on the motor power lines. This means that the SubMonitor Connect reading difference can be
between 505 A and 495 A.
Refer to "Wiring Diagrams for Panels" on page 59

Start-Up Programming

Using the Control Interface

Display: Shows system status information
1.
and programming menu items.
2. SHIFT: Press SHIFT to move the blinking
cursor left one position for each button
press. When the cursor reaches the left-
most editable position, another SHIFT
button press moves the cursor to the
right-most position of the parameter.
3. UP and DOWN: Use to navigate menus
and adjust parameters.
4. ENTER: Executes menu selection and con-
firms any changes made to parameter
settings. Also allows user to access sub-
menus and selected parameters.
5. ESC: Pressing the ESC button moves the menu back one level.
6. Run LED: This green LED lights to alert the user to water flow (the pump motor is running).
7. Fault LED: Off (when not lighted) indicates normal operation. A blinking LED indicates the measured
current is higher than the Overload setting, and will trip soon if the condition persists. A solid on LED
indicates an active fault condition.
Remove the detachable display for access to these items:
TEST/RESET: Pressing this button resets a fault condition, if present. In a non-fault condition, pressing
this button puts the SubMonitor Connect into a fault state.
for schematics.
INSTALLATION AND SETUP
Start-Up Programming
for External CT Ratio
15