Franklin Electric SUBMONITOR CONNECT Manuel D'installation Et D'utilisation page 23

Mod
RW RC Display Name
bus
455 RW N Underpower Reset 0 - Manual
456 RW N Underpower Retry 1 to 10; default = 3
457 RW N Underpower Reset
Delay
Overpower menu
458 RW N Trip/Alarm
459 RW N Overpower Level
460 RW N Time to Trip
461 RW N Fault Reset Type
462 RW N Reset Retries
463 RW N Reset Delay
Negative Power menu
464 RW N Trip/Alarm
Underpower menu
452 Trip/Alarm
453 Underpower Level 101 to 200; default = 125
454 Time to Trip
455 Fault Reset Type
456 Reset Retries
457 Reset Delay
Programming: Advanced Setup > Motor Protection > System
Mod
RW RC Display Name
bus
Insulation Check menu
465 RW N Trip/Alarm
466 RW N Fault Resistance
467 RW N Alarm Resistance
SubTemp menu
468 RW N Trip/Alarm
469 RW N Trip Temp
470 RW N Alarm Temp
Programming: Advanced Setup > Motor Protection > System
Range
1 - Automatic
2 - Well Recovery (Submers-
ible Pump only)
1 to 43,200; default = 900
0 - Off
1 - Fault and Alarm (default)
2 - Alarm Only
101 to 200; default = 125
1 to 120; default = 3
0 - Manual
1 - Automatic (default)
1 to 10; default = 3
1 to 43,200; default = 900
0 - Off (default)
1 - Fault and Alarm
2 - Alarm Only
0 - Off
1 - Fault and Alarm (default)
2 - Alarm Only
1 to 120; default = 3
0 - Manual
1 - Automatic (default)
1 to 10; default = 3
1 to 43,200; default = 900
Range
0 - Off (default)
1 - Fault and Alarm
2 - Alarm Only
1 to 2000; default = 500
1 to 3000; default = 1000
0 - Off (default)
1 - Fault and Alarm
2 - Alarm Only
0 to 150; default = 40
0 to 150; default = 30
INSTALLATION AND SETUP
Description
Underpower Reset Method
When set to well recovery, the SubMonitor Connect
infinitely resets an Underpower fault condition based on
the user-selected reset delay.
Underpower Automatic Reset Attempts
Underpower Reset Delay in seconds
Choose the type of response for when an Overpower con-
dition is detected.
Over Power Level Percentage
Over Power Delay Time in seconds
Over Power Reset Method
Over Power Automatic Reset Attempts
Over Power Reset Delay in seconds
Choose the type of response for when Negative Power is
detected.
Choose the type of response for when Underpower is
detected.
Underpower Level Percentage
Underpower Delay Time in seconds
Over Power Reset Method
Underpower Automatic Reset Attempts
Underpower Reset Delay in seconds
Description
Insulation Check Enable. This measures an approximate
resistance between the W circuit and earth ground.
Insulation Resistance Fault Level
Insulation Resistance Alarm Level
SubTemp Motor Protection Enable
SubTemp Fault Trip Temperature setting in °C
SubTemp Alarm Trip Temperature setting in °C
23