Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION AND SETUP
Physical Installation
Physical Installation
Environmental Requirements
Risk of damage or malfunction to SubMonitor Connect
improper handling, installation, or environment.
•
Handle with care to prevent damage to the SubMonitor Connect components and panels.
•
Install SubMonitor Connect Component models inside a complete control panel enclosure.
•
End-use installation shall not subject components or assemblies to excessive vibration.
•
Components and assemblies shall be located where temperatures are within product ratings.
•
Do not mount in direct sunlight or near other heat sources.
•
MT1111/MT6111: Install SubMonitor Connect on a non-combustible surface. The SubMonitor Connect
generates some heat during normal operation.
The SubMonitor Connect must be installed and used in a controlled environment that meets the following
rating requirements:
Operating Temperature
Storage Temperature
Relative Humidity
Dimensions
10
-4 to 140 °F (-20 to 60 °C)
-40 to 158 °F (-40 to 70 °C)
5% to 95% (non-condensing)
,
can occur due to
Publicité
Chapitres
Table des Matières
Dépannage
