Install Blower - KitchenAid KSDG950ESS Manuel Du Propriétaire

Complete Connection
1. Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
A. Closed Valve
B. Open Valve
2. Test all connections by brushing on an approved noncorrosive
leak-detection solution. If bubbles appear, a leak is indicated.
Correct any leak found.
3. Remove cooktop burner caps and bases from package
containing parts. Place the burner bases as indicated below:
A. Small (Auxiliary)
B. Large (Ultra Rapid)
NOTE: Each round burner base is marked with one of the
following: AUX, SR, or UR.
4. Align the gas tube opening in the burner base with the orifice
holder on the cooktop and the igniter electrode with the notch
in the burner base.
A. Burner cap
B. Gas tube opening
C. Burner base
26
C. Medium (Semi Rapid)
D. Large (Ultra Rapid)
D. Igniter electrode
E. Orifice holder
5. Place the burner caps on the appropriate burner bases.
NOTE: The bottom of the small and medium caps are
different. Do not put the wrong size burner cap on the burner
base. Each round burner cap is marked with an AUX, SR, or
UR to match with a letter on the burner base.
Small cap Medium cap (Semi
(Auxiliary)
Burner caps should be level when properly positioned. If
burner caps are not properly positioned, surface burners will
not light. The burner cap should not rock or wobble when
properly aligned.
A. Incorrect
B. Correct
6. Place burner grates over burners and caps.
7. Plug into appropriate outlet. See the appropriate "Electrical
Requirements" section.
8. Turn on power.

Install Blower

Install Blower Cover
1. Locate blower motor cover.
2. Run the blower motor wires with strain relief through the small
opening in the blower motor cover, starting from the inside and
feeding out.
Large cap (Ultra
Rapid) Rapid)