Rockwell Automation Allen Bradley SLC 5/03 Notice D'installation page 8

8
Power Supply and LED Indicators
POWER RUN
FLT
BATT
RUN
POWER
FLT
BATT
Load Your Software
Refer to your programming software documentation.
Establish Communication to the Processor
1. Refer to the following table to establish communication between the
processor and your personal computer.
Processor Procedure
SLC 5/03 Connect 1747-PIC from the processor to your personal computer or a 1747-CP3
cable from channel 0 of the processor to the personal computer serial port.
SLC 5/04 Connect a 1747-CP3 cable from channel 0 of the processor to the personal
computer serial port or use a 1784-KT, 1784-KTX, 1784-KT2, or 1784-PCMK
card.
SLC 5/05 Connect a 1747-CP3 cable from channel 0 of the processor to the personal
computer serial port or use a 1784-KT, 1784-KTX, 1784-KT2, or -PCMK card.
For Ethernet connection, connect channel 1 of the processor and the PC
Ethernet Card (or 1784-PCMK) to an Ethernet hub using 10Base-T cable.
(1) Ethernet IP address must be set via an RS-232 connection.
Publication 1746-IN009B-MU-P - February 2002
FORCE
DH485
RS232
SLC 5/03
FORCE
DH+
RS232
SLC 5/04
Indicates the LED is OFF
Indicates the LED is ON
Indicates the LED is FLASHING
Status of LED does not matter
RUN FORCE
POWER
FLT ENET
BATT RS232
SLC 5/05
(1)