Required Tools And Equipment; Safety Considerations - Rockwell Automation Allen Bradley SLC 5/03 Notice D'installation

6

Required Tools and Equipment

• medium blade screwdriver
• programming equipment
• a 1747-PIC, 1784-KTX, or 1784-PCMK communication interface (or standard
Ethernet PC board - SLC 5/05 only)

Safety Considerations

ATTENTION
!
For general recommendations concerning installation safety requirements and
safety related work practices, refer to the requirements specific to your region.
• Europe: Reference the standards found in EN 60204 and your national
regulations.
• United States: refer to NFPA 70E, Electrical Safety Requirements for Employee
Workplaces.
IMPORTANT
Publication 1746-IN009B-MU-P - February 2002
Never install, remove, or wire any module while power is
applied. Also, do not expose processor modules to surfaces or
other areas that may typically hold an electrostatic charge.
Electrostatic charges can alter or destroy memory.
See page 13 for information on proper battery handling,
storage, and transporting.