Flap Discs For Metal; Other Accessories; Adjusting The Disc Guard Cover - Parkside PWS 125 A1 Instructions D'utilisation Et Consignes De Sécurité

Use of accessories
ø 125 x 22.2 mm
to max. 6 mm thick
(depressed centre)
12000 rpm
80 m / sec

Flap discs for metal

Q
Dimensions:
Speed:

Other accessories

Q
You can also use abrasive consumables and tools
complying with the following technical specification:
Spindle thread:
Speed:
Backing plate for grinding discs
Dimensions:
Grinding discs for wood / masonry attached
with hook and eye fixings
Dimensions:
64 GB
ø 125 mm
min. 12000 rpm
M14
min. 12000 rpm
ø 115 mm / 125 mm
ø 115 mm / 125 mm
Note! These may only be used in combination
with a backing plate!
Cup brush, crimped wire
Dimensions:
Speed:
Cup brush, twisted wire
Dimensions:
Speed:
Cup brush, knotted wire
Dimensions:
Speed:

Adjusting the disc guard cover

Q
Pull the mains plug out of the mains socket
before you carry out any task on the device.
In order to adjust the safety cover
not need to remove the screws
sen them.
ø 75–100 mm
min. 12000 rpm
ø 75 mm
min. 12000 rpm
ø 115 mm
min. 12000 rpm
DANGER OF INJURy!
, one does
5
but just loo-
12