Introduction; Proper Use; Features And Equipment - Parkside PWS 125 A1 Instructions D'utilisation Et Consignes De Sécurité

Introduction

The following pictograms are used in these operating instructions / on the device:
Read instruction manual!
Observe caution and safety notes!
Caution – electric shock!
Danger to life!
Risk of explosion!
Risk of fire!
V ~
Volt (AC)
W
Watts (effective power)
Angle grinder PWS 125 A1
Grinding, roughing, cutting
Introduction
Q
We congratulate you on the purchase of
your new device. You have chosen a high
quality product. The instructions for use
are part of the product. They contain important in-
formation concerning safety, use and disposal. Be-
fore using the product, please familiarise yourself
with all of the safety information and instructions
for use. Only use the unit as described and for the
specified applications. If you pass the product on
to anyone else, please ensure that you also pass
on all the documentation with it.

Proper use

Q
The device is intended for the dry cutting, rough
grinding and brushing of metal and stone. Any other
use or modification to the device shall be considered
as improper use and could give rise to considerable
dangers. We will not accept liability for loss or
54 GB
n
Rated speed
Safety class II
Proper procedure and handling.
Wear hearing protection, dust
protection mask, protective glasses
and protective gloves.
Keep children away from electrical
power tools!
Risk of loss of life by electric shock
from damaged mains lead or mains
plug!
Dispose packaging and appliance in
an environmentally-friendly way!
damage arising from improper use. The device is
not intended for commercial use.
Note: Slots cut in load-bearing walls must comply
with standard DIN 1053 Part 1 or the regulations
applicable in your country.
These instructions and advice must be observed.
Before you start a task, seek the advice of a com-
petent structural engineer, architect, or the relevant
site management staff.

Features and equipment

Q
Safety lock-out
1
ON / OFF switch
2
Carbon brushes cover
3
Auxiliary handle
4
Adjustable disc guard
5
Clamping nut
6
Mounting spindle
7
Mounting flange
8
Spindle lock button
9
Speed pre-selector wheel
10
Spanner (Fig. B)
11