Operation; Switching The Display On - Allmatic Clamp assist Instructions De Service

8 | Operation

1. Insert rechargeable batteries in accordance with the instructions in the battery compart-
ment (see Charging the LEE and Replacing Batteries [} 51]).
2. Completely charge batteries on initial commissioning. A complete charging cycle takes ap-
prox. 12 hours.
ð MEE ready for operation.
NOTE
Deep discharge of the rechargeable batteries.
Damage to the rechargeable batteries.
Ø Remove rechargeable batteries if the MEE is not used for a long period (> three
8 Operation
Before the MEE can be used, the batteries must be charged.
In order for the MEE to be used with a CA spindle, the MEE must first be connected to the CA
spindle, see Coupling Mode [} 43]
8.1

Switching the Display On

To switch the display of the MEE on, press the button
The display is switched off after 5 minutes or by pressing the button
40 / 294
weeks).
.
.
Clamp assist
ALLMATIC