Troubleshooting - Pattfield Ergo Tools PE-EKS 1835 Notice Originale

11. Troubleshooting

Danger!
Before troubleshooting, switch off the tool and disconnect the mains
plug.
The table below contains a list of fault symptoms and explains what
you can do to remedy the problem if your tool fails to work properly.
If the problem still persists after working through the list then please
contact your nearest service workshop.
Cause
Chainsaw
does not
work at all
Chainsaw
operates in-
termittently
Anl_PE_EKS_1835_SPK7.indb 307 Anl_PE_EKS_1835_SPK7.indb 307
Fault
- Quick stop brake has
been triggered
- No power supply
- Defective mains outlet
- Power extension cable
damaged
- Defective fuse
- Power cable damaged
- Loose connection (ex-
ternal)
- Loose connection (in-
ternal)
- ON/OFF switch defecti-
ve
- 307 -
Remedy
- Pull the hand protection
back to the normal po-
sition.
- Check the power sup-
ply.
- Try an alternative sour-
ce of electrical power,
replace if necessary.
- Check the cable and
replace as required.
- Replace the fuse.
- Consult a specialist
workshop.
- Consult a specialist
workshop.
- Consult a specialist
workshop.
- Consult a specialist
workshop.
GB
17.11.2017 12:33:26 17.11.2017 12:33:26