Carbon Brushes - Pattfield Ergo Tools PE-EKS 1835 Notice Originale

9.1 Cleaning
•
Regularly clean the clamping mechanism by blowing it out with
compressed air or cleaning it with a brush. Do not use tools for
cleaning.
•
Keep the handles free of grease so that you can maintain a firm
grip.
•
Clean the device as required with a damp cloth and, if necessary,
mild washing up liquid.
•
If the chainsaw is not to be used for an extended period of time
then you should remove the chain oil from the tank. Briefly immer-
se the saw chain and the cutter rail in an oil bath and then wrap
them in oil paper.

9.2 Carbon brushes

In case of excessive sparking, have the carbon brushes checked
only by a qualifi ed electrician.
Danger! The carbon brushes should not be replaced by anyone but
a qualifi ed electrician.
9.3 Maintenance
GB
Replacing the saw chain and cutter rail
The cutter rail needs to be replaced if
•
the guide groove of the cutter rail is worn;
•
the nose sprocket in the cutter rail is damaged or worn.
Proceed as described in the section "Assembly of the cutter rail and
the saw chain".
Anl_PE_EKS_1835_SPK7.indb 304 Anl_PE_EKS_1835_SPK7.indb 304
- 304 -
17.11.2017 12:33:25 17.11.2017 12:33:25