Checking the automatic chain lubrication
You should check the operation of the automatic chain lubrication
system on a regular basis in order to guard against overheating and
the associated damage to the cutter rail and the saw chain. To do
this, point the tip of the cutter rail towards a smooth surface (board,
section of a cut tree) and allow the chainsaw to run.
If an increasing oil trace becomes evident during this process then
the automatic chain lubrication system is working properly. If no clear
oil trace is evident then please refer to the corresponding instructions
in "Troubleshooting". If the information contained there still fails to
remedy the situation then please contact our service department or
another similarly qualifi ed workshop.
Danger! Do not actually touch the surface with the tip of the cutter
rail when performing this test. Keep a safe distance (approx. 20 cm).
Sharpening the saw chain
Eff ective working with the chainsaw is only possible if the saw chain
is in good condition and sharp. This also reduces the risk of kickback.
The saw chain can be re-sharpened by any dealer. Do not attempt to
sharpen the saw chain yourself unless you have the necessary spe-
cial tools and experience.
9.4 Ordering replacement parts:
Please quote the following data when ordering replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
Current prices and information are available on request at your Horn-
bach store.
Anl_PE_EKS_1835_SPK7.indb 305
Anl_PE_EKS_1835_SPK7.indb 305
- 305 -
GB
17.11.2017 12:33:25
17.11.2017 12:33:25