GYS TART 12.24T Mode D'emploi page 9

Translation of the original instructions
• Regularly take off the cover and remove dust with an air gun. Take
the opportunity to have a qualified person check the electrical
connections with an insulated tool.
• Under no circumstances should solvents or other aggressive cleaning
agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations :
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.
GENERAL DESCRIPTION
Thank you for choosing this GYS product which has been designed with great care. To get the best out of your machine,
please read the following instructions carefully, and keep for future reference.
The GYSTARTs are designed to start vehicles with liquid or gel electrolyte lead-acid batteries and also charge liquid or gel
electrolyte lead-acid batteries. They are for use on 12V or 24V batteries with a capacity according to the table below :
GYSTART
1224T
Charge 65>1350 Ah
Start
60>300 Ah
ELECTRICITY SUPPLY
This device must be plugged into an EARTHED power supply with the following characteristics :
GYSTART 1224T
Voltage 400V 3 ph.
Protection
16A
Recommended cable section for use on extension cables: 3 x 2.5 mm² (4 x 2.5 mm² for the 1224T).
USE IN STARTING MODE (START)
Prior precautions
• Choose a sheltered area with suitable ventilation.
• Remove the battery caps (if present) and ensure the liquid level (electrolyte) is correct. Add some distilled water if
necessary. Carefully clean the lugs and terminals of the battery.
• Check that the capacity (Amps per hour) and the voltage (Volts) are compatible with your charger.
Connecting and Disconnecting
• Switch off the product by selecting position "0". Then plug into the mains supply and turn the charge current poten-
tiometer to the lowest setting.
• Select the correct voltage 12 or 24 V for the battery.
• Connect the clamps: red to + terminal, black to – battery terminal.
• Make sure you get good electrical contact.
• Select the charging mode using the switch :
"Electronic control": when the charging process is over, a light will illuminate.
"Manual mode": stop the charging process when your battery starts to boil. Be careful of explosive gas, avoid flames
or sparks.
GYSTART 12.24T EN
9