Assembly; Stuffer Assembly - Weston 73-0501-W Instructions

ASSEMBLY

PLUNGER ASSEMBLY
1. Slide the Plunger Seal
onto the Plunger (FIGURE
1).
2. Assemble the Pressure
Release Valve Kit onto
the Plunger. From the top
of the Plunger, place the
Washer onto the Valve
Hole, then insert the
Screw through the Washer
and into the Valve Hole.
From the underside of the
Plunger, place the Spring
onto the end of the Screw,
then place the Valve Cap
onto the end of the Screw
and twist to secure.
3. Place the assembled
Plunger onto the end of the
Plunger Shaft (FIGURE 2).

STUFFER ASSEMBLY

4. Attach the Handle by
sliding it onto the Gear
Shaft and placing the
Wingnut into the hole in the
Handle. Twist to tighten
(FIGURE 3).
5. Crank the Handle
counter-clockwise to bring
the Plunger to the top of
the Stuffer.
6. Rest the Canister's
Bottom Brackets onto
the Canister Mounts
inside the Housing of the
Stuffer. Pivot the bottom
of the Canister into the
Stuffer Housing. Pivot
the Canister fully into the
Stuffer Housing, snapping
the Top Brackets into the
Canister Mounts (FIGURE
4).
6
FIGURE 1
Plunger
Seal
Pressure
Release
Valve Kit
Screw
Washer
Plunger
Spring
Valve Hole
Valve Cap
FIGURE 3
Gear Shaft
Wingnut
Outside view of
Canister Mounts
FIGURE 2
Handle
Top Brackets
Bottom Brackets
FIGURE 4