Components; Cleaning Instructions; Assembly - Weston 07-0301 Mode D'emploi

COMPONENTS

Thickness
Adjustment Knob
Locking
Wing Nut
Adjustment
Adjustment Screw
Plate
Base
Plate
If any components of this unit are broken, the unit does not operate properly or you
need a replacement instruction manual, visit us on the web at
WestonBrands.com

CLEANING INSTRUCTIONS

Before and after each use, disassemble and wash all parts of this product that
come in contact with food. Wash all parts in warm, soapy water. Rinse with clear
water. Dry immediately.
This product is NOT dishwasher safe.
1. Completely remove the Thickness Adjustment Knob and the Locking Wing Nut
from the Adjustment Screw by turning counter-clockwise.
2. Hold on to the top of the Burger Press and turning counter-clockwise, unscrew
the Adjustment Plate and Adjustment Screw from the Burger Press.
3. Clean all parts in warm soapy water, then thoroughly dry.

ASSEMBLY

1. By holding on to the top of the Burger Press, screw the Adjustment Plate
and Adjustment Screw into the top of Burger Press by turning clockwise until
approximately half the threads are showing on top of the Burger Press.
2. Re-thread the Locking Wing Nut onto the Adjustment Screw. Pay special
attention not to cross-thread any parts when assembling.
3. Screw the Thickness Adjustment Knob clockwise onto Adjustment Screw until
finger tight.
3