Assembly Instructions For Manual Operation - Weston 36-2001-W Mode D'emploi

ASSEMBLY INSTRUCTIONS FOR MANUAL OPERATION

1. Place the Mixing Tub on a stable,
level surface with the Pivot Knob on
your left and the Gear Housing Cover
on your right (FIGURE 1).
2. Adjust the Feet so the Meat Mixer
is stable and level. Raise the Locking
Nuts until they contact the bottom of
the Meat Mixer. Tighten the Locking
Nuts against the bottom to secure the
Feet in position.
3. Insert the hollow end of the Brass
Pivot Pin, notched side down, into
the Pivot Housing from inside the
Mixing Tub (FIGURE 2).
4. Using the Wrench, tighten the Set
Screw nearest the Mixing Tub on the
underside of the Pivot Knob Post until
it stops. Loosen the Set Screw ¼ turn
to allow the Brass Pivot Pin to slide
back and forth (figure 3). Make sure
the Set Screw fits in the notch in the
Brass Pivot Pin.
5. Insert the threaded end of the Pivot
Knob into the Pivot Knob Post from
outside the Mixing Tub (FIGURE 2).
6. Screw the Pivot Knob into the
Brass Pivot Pin until tight.
7. Install the notched end
of the Mixing Shaft onto
the Pin on the Mixing
Shaft Pinion inside the
Mixing Tub. It is best to
have the Paddle nearest
the notched end of the
Mixing Shaft pointing
downward. You may
have to align the Pin
with the notch to install
the Mixing Shaft in this
position. If so, install the Handle onto
the Drive Shaft. Rotate the Handle
until the Pin aligns with the notch.
Remove the Handle.
Pivot
Knob
Post
Mixing
Tub
Rubber
Feet
Pivot
Housing
Inside View of
Mixing Tub
Pivot
Knob
Pivot
Knob
Post
Set
Screws
Notched End of
Mixing Shaft
Mixing
Shaft
Mixing Shaft
Pinion
FIGURE 1
Gear
Housing
Cover
FIGURE 2
Pivot
Pin
FIGURE 3
5