Assembly & Changing The Blade - Weston 36-3301-W Instructions

ASSEMBLY & CHANGING THE BLADE
w WARNING Cut Hazard. Blades are sharp, use care when handling. The
use of cut-resistant gloves is suggested.
1. Insert the Blade, Blade Tab end first up
through the slot in the bottom of the Base.
The front of the Blade will face outwards
(FIGURE 1). The Blade will click into
place.
2. Slide the Knife Guide Tab into the path
underneath the Base until it clicks securely
into place (FIGURE 2).
3. With the Pusher Tabs pointing upward,
and the Pusher Nubs facing outward, place
the Pusher flat onto the face of the Ratchet
Handle and slide upward into place. The
slots on the Pusher will align with the slots
on the Ratchet Handle. The Pusher will
click into place (FIGURE 3).
4. Place the Ratchet Handle/Pusher
assembly onto the end of the Base
(FIGURE 4).
5. Pull the Ratchet Handle forward slightly
and push down on the Handle. (This will
allow the Ratchet Clips to latch into the
Ratchet Brackets.) (FIGURE 5 & 5A).
6. To change the Blade, pull up on the
Handle to release the Ratchet Handle from
the Base. Remove the Ratchet Handle.
7. From the underside of the Base, gently
pull down on the Knife Guide Tab and pull
the Knife Guide off of the Base.
8. Push the Blade Tab down to release the
Blade from the Base.
9. Push the Pusher Tabs down to release
the Pusher from the Ratchet Handle.
10. Replace the Blade and the Pusher
following instructions 1-3 on this page.
FIGURE 4
Front of
Blade
Blade Tab
Knife Guide
Tab
Pusher Tabs
Pusher
Nubs
Ratchet
Handle
FIGURE 5
Base
FIGURE 1
Base
Back of Blade
Front of Blade
FIGURE 2
FIGURE 3
Handle
Ratchet Handle
Ratchet
Brackets
FIGURE 5A
Ratchet
Clips
5