Maintenance; Inspection And Cleaning; Fault Tracing; Ordering Of Spare Parts - ESAB Origo Mig 410 Manuel D'instructions

GB
7

MAINTENANCE

Regular maintenance is important for safe, reliable operation.
Note!
All guarantee undertakings from the supplier cease to apply if the customer himself
attempts any work in the product during the guarantee period in order to rectify any
faults.
7.1

Inspection and cleaning

Check regularly that the power source is free from dirt.
The power source should be regularly blown clean using dry compressed air at reduced
pressure. More frequently in dirty environments. Otherwise the air inlet/outlet may be-
come blocked and cause overheating. To avoid this you can use an airfilter. The airfilter
is an accessory. Ordering number can be found on page 47.
8

FAULT TRACING

Try these recommended checks and inspections before sending for an authorised service technican.
Type of fault
No arc
Welding current is interrupted
during welding
Thermal overload trips
operate frequently
Poor welding performance
9

ORDERING OF SPARE PARTS

TM
Origo Mig 410 & Origo
ternational and European standards IEC/EN 60974- -1 and EN 60974- -10. It is the obliga-
tion of the service unit which has carried out the service or repair work to make sure
that the product still conforms to the said standard.
Spare parts may be ordered through your nearest ESAB dealer, see the last page of
this publication.
mi410,510e
Check that the mains power supply switch is turned on.
S
Check that the welding current supply and return cables are
S
correctly connected.
Check that correct current value is set.
S
Check to see whether the MCB has tripped.
S
Check whether the thermal overload trip has operated
S
(indicated by the orange lamp on the front).
Check the main power supply fuses.
S
Check to see whether the air filters are clogged.
S
Make sure that you are not exceeding the rated data for the
S
power source (i.e. that the unit is not being overloaded).
Check that the welding current supply and return cables are
S
correctly connected.
Check that the correct current value is set.
S
Check that the correct welding wires are being used.
S
Check the main power supply fuses.
S
TM
Mig 510 is designed and tested in accordance with the in-
- - 14 - -
Actions