Titan ProMark 98:2 Série Mode D'emploi page 17

ProMark
TrAce fuNcTIoN
From the Main Menu
screen, press the 'Trace'
button to display this
screen.
The user can set the
Cycle and Skip length
they wish to trace.
For example, if the
pattern being put
down is a 10-foot line
with a 10-foot gap, the
user would enter '10' in
the Skip box and '20' in
the Cycle box. (10' line
+ 10' gap = 20' cycle).
The machine can mark one line or two lines simultaneously.
If the operator entered in a single gun to be used, the values
in the Cycle 2 and Skip 2 boxes will be ignored.
The user MUST make sure the toggle switches for both guns
are set to the idle (Neutral) position before starting. The
machine will put a mark at the beginning and end of the
line.
To start tracing press the red button on the handle. To stop
the trace press the red button again.
eNcoDer ScAle
At any time the
operator can view/
change the encoder
scale (calibration
number) and the
gallons per pulse.
Pressing the 'F4' button
will bring up the
System Settings screen
There are two boxes that will allow the operator to adjust
how long each gun stays on when marking stalls or tracing
lines. These times are set to milliseconds. The default for
each system should be 0ms. Depending on the size of the
mark the operator can increase or decrease that number
accordingly.
The '2 Pumps' setting will adjust the system to account for
two material pumps on your machine.
If you are spraying a 2 part material leave the 'Dual Color'
option unselected. If you are spraying two different colors
of material select the 'Dual Color' option. Selecting 'Metric'
will switch the unit to measure values in meters and liters.
pArkINg loT lAyouT
From the Main Menu
screen, press the
'Parking Lot Layout'
button to get to the
Parking Lot Layout
screen.
From here the operator
can choose one of the
following options:
•
Measure Stalls – used to determine the width of each
stall.
•
Stripe Stalls – Used to mark parking stalls
•
Marker Layout – for marking up to 8 different distances
at one time
•
Angle Stall Layout – used for marking stalls that are at
an angle
Each of these options has its own screen. See below.
meASure STAllS
Make sure machine
is in position before
pressing the 'Measure
Stalls' button
From this screen the
operator can determine
stall width based on
the distance travelled
and the number of
desired stalls.
Once the operator is in position and ready to determine stall
width, start moving the machine across the parking lot until
you have reached the end. Distance will start incrementing
as the machine moves.
Once the operator gets to the end, enter the number of
stalls by pressing inside the '# of Stalls' box. Using the digital
keypad, enter the number of stalls that are desired and press
'Enter' to finish.
Operator will notice in the lower left corner of the screen
the "Stall Size" has been calculated based off the distance
travelled and the number o f stalls desired. The operator can
increase/decrease the number of stalls until satisfied.
To save the stall size the operator needs to press the 'Use
Data' button in the lower right corner.
Pressing the 'Use Data' button will bring the operator to the
'Stripe Stalls Screen' on the next page.
To back up from this screen without saving any information,
press the F1 key which will be labeled 'Main" on the unit'.
description of unit
17