Disassembling The Appliance; Cleaning And Care - WMF Profi Plus Mode D'emploi

7 | DISASSEMBLING THE APPLIANCE

▪ After you have turned the control knob to "0", pull out the mains plug.
▪ Gently press the mains plug cable into the inlet for the mains switch (11) so that the appliance can
be stowed away more easily.
▪ Pull the stopper (8) out of the fi lling opening.
▪ Remove the fi lling bowl (4).
▪ Press the meat attachment ejection symbol (k)
knob (7), to release the mincer attachment (2) from the casing.
Note: If the control knob (7) does not point to "0", the mincer attachment (2) cannot be removed
for safety reasons.
▪ Remove the assembled mincer attachment (2) by turning it slightly anticlockwise.
Note: For easy removal of the grates (13, 14, 15), push the feeding screw
L
out of the mincer attachment (2) from behind (see fi gure L).

8 | CLEANING AND CARE

Never use abrasive or harsh cleaning agents!
Important! Never insert your fi ngers or your hand into the fi lling opening or insert objects into the
openings of the grates (13, 14, 15) as long as the mains plug has not been pulled out.
Loosen the threaded ring (6) and disassemble the attachment. Rinse all parts thoroughly in warm
water.
For easier and more thorough cleaning of the grates (13, 14, 15) use the cleaning aid for grates (22).
Note: The grates must be positioned appropriately on the cleaning aid (see fi gures M, N and O).
M
Cleaning the small grates (13) Cleaning the medium grates (14)
32
, which is located in the centre of the control
N O
Cleaning the coarse grates (15)
Important! Never clean the threaded ring (6), the mincer attachment (2) or the feeding screw (9) in
a dishwasher! Dishwasher detergents can cause corrosion and discolouration. The parts concerned are
marked with the following symbol for safety purposes:
33