Superwinch TERRA Serie Guide D'installation page 5

8
Before testing winch operation, be sure to reel off approximately
WARNING
!
two feet of rope.
!
TEST DRIVE
1. Double check that all wiring is correct and that there are no exposed terminals that
can short to the vehicle frame.
2. Turn the ignition key to the ON position. Check winch for proper operation.
REMOTE SOCKET MOUNTING - optional
1. Determine the mounting location for the remote socket.
2. Drill three holes using the included dimensions as a guide.
3. Once the remote socket is mounted, route the jacketed green and black leads back
to where the solenoid is mounted. Splice the red lead to a key controlled electrical
wire on the ATV.
Ø
1.03"
Ø
26.2 mm
Fig. 7 - Socket Assembly mounts
from the outside, inward.
THE COMPLETE KIT
Hand held
Remote
Fig. 8
Winch
1.77"
44 mm
Ø .26"
Ø 6.5 mm
Ø .89"
Ø 22.5 mm
Rocker
Switch
Solenoid
Socket
Assembly
9