Spare Parts That May Need Replacement - arilex 2H Manuel D'installation

4. POSIBLE BREAKDOWNS
- Burners are not lit
a.- Fuel does not arrive, check that the faucet of the supply network is open
and if using a bottle, check that it is full.
- The flame gives off black gases and has a strong yellow color
a.- Obstruction of the burner injector. Proceed to clean.
b.- Lack of primary air, check that nothing is closing the air inlets and outlets
located on the back and side of the grill.
- When you stop pressing the control tap, the burner goes out
a.- You must keep pressed at least 15 seconds.
b.- Defective thermocouple, replace thermocouple.
- The burners are extinguished
a.- It is running out of gas proceed to change the bottles.
b.- The gas flow that is needed is higher than the bottle can give, the bottle
freeze place a second bottle.
c.- If you use butane gas, check that the ambient temperature is not lower
than -4ºC change to propane gas.
- Only the first plates are infrared
Check the supply pressure, a wrong supply pressure will cause the burner
not to work properly.

5. SPARE PARTS THAT MAY NEED REPLACEMENT

Injector .- See section 2.4 Change of gas type and thermocouple. - On the
side of the burner "unscrew" and pull on the side of the tap.
WARRANTY CONDITIONS
The roaster has a one year warranty from the date of purchase against
any manufacturing anomaly.
Are cause for warranty extinction:
- Any breakdown caused by normal wear and tear over time.
- Any breakdown caused by misuse of the device or by not ignoring the
instruction manual.
- In general, anyone with cause not attributable to the manufacturer.
20