Primary Air Regulation; Minimum Gas Regulation; Electric Equipment; Starting The Device - arilex 2H Manuel D'installation

1º Remove the side cover
2º Loosen the injectors
3º Remove the injectors with a wrench
4º Place the new injectors
It is not necessary to regulate the primary air.

2.6. PRIMARY AIR REGULATION

En este aparato no es necesaria la regulación del aire primario.

2.7. MINIMUM GAS REGULATION

Turn on the burner and place the knob pointing to the small flame.
Remove the knob from the tap "gently pulling on it"; A screw located on
the left side of the shaft will be visible.
Use a slotted screwdriver to turn the screw clockwise to reduce the
height of the flame and counterclockwise to increase the height.
2.8. ELECTRICAL EQUIPMENT
It consists of a motoreductor that works at 230V, with a speed of rotation
of 4 r.p.m. which rotates all the swords synchronously by means of a
chain, said motor is activated by means of a switch where the positions
(0) are shown off and (1) in operation, which switch is also luminous and
being illuminated in the position ( one).
The rotisserie must be connected to a switch provided with a thermal
magnet that protects the user from possible accidental contacts or due
to alterations of the machine.

2.9. STARTING THE DEVICE

a.- Open the gas passage of the general supply network.
b.- Connect the electric cable
1.- Ignition of the burners
-The lighting order is from top to bottom, NEVER TURN ON A BURNER
WITHOUT HAVING THE SUPERIOR BURNER ON, SINCE IT WOULD
BE VERY DIFFICULT TO TURN IT ON AND IT COULD BURN
16