Canifugue Pro Receiver Collar - Num'axes Canifugue PRO Guide D'utilisation

Warning area indicator
Stimulation area
indicator
• Activate/deactivate the CANIFUGUE PRO/CANIFUGUE MIX transmitter
• Activate: connect the transmitter to the power supply by plugging the AC adapter into the power jack on the transmitter and into a wall outlet.
Indications appear on the LCD screen, the transmitter is On.
• Deactivate: disconnect the AC adapter from the wall outlet.
The LCD screen goes out, the transmitter is Off.
NOTE: do not connect the transmitter to the power supply before connecting the antenna wire to the antenna socket. The wire break alarm would alert
you to a connexion default (ref. § Safety features).
When you disconnect the transmitter, the boundary settings are memorized. Next time you will activate the transmitter, the settings will be the last
selected.

CANIFUGUE PRO receiver collar

•
• Description
Contact points
(short or long)
Area where the magnetic switch is located
This magnetic switch allows you to turn On/Off the
collar and to select the stimulation level (modes)
• Charge of the CANIFUGUE PRO collar
To charge your collar, proceed in the following way:
− connect the charger to a wall outlet
− connect the power cord to the collar (after a few seconds, the green indicator light starts blinking every 5 seconds)
− when the battery is fully charged, the green indicator light goes out
− disconnect the charger from the collar and put the protection tab back in place
− disconnect the charger from the wall outlet
We advise you to fully charge the battery before the 1st use.
A full charge takes approximately 3 hours.
You can purchase a car charger from your supplier at any time.
• Activate/deactivate the CANIFUGUE PRO colla
The supplied magnetic key allows you to activate/deactivate the collar.
• Activate:
move the magnetic key towards the collar so that it comes into contact with the area
where the magnetic switch is located (ref. Diagram 5). Keep them both in contact a few seconds.
The collar will emit 2 beep sounds and the green indicator light will flash every 5 seconds indicating
that the collar is On.
Diagram 3 LCD screen
Diagram 4 CANIFUGUE PRO collar
Area where the green
indicator light is located:
On/Off indicator
+
Battery charge level
indicator
Magnetic key
(magnet)
r
Gb - 18
Small / large ground
indicator
Broken antenna wire
or connection default
indicator
Charging jack
protection tab
Diagram 5
Activate/deactivate
the CANIFUGUE PRO collar
with the magnetic key