Regular Inspections; Weekly Maintenance - IDC Mill 5X Mode D'emploi

8.1.2

Regular inspections

_ Condition of the bellow
_ Condition of hoses and drain pipes
▷ Keep the door gasket and the stopping surface
on the door clean. Ensure not to damage the
sealing lips.
8.1.3

Weekly maintenance

NOTE:
Danger of damaging the machine!
▷ Do not use compressed air, ultrasonic or a
steam jet for the cleaning!
Prior to maintenance:
Before maintaining the spindle and the C/L noz-
zles, the spindle sealing air must be activated:
▷ Briefly press service button [B].
The current tool is placed down and the spindle
returns to the service position. The spindle is
released; the motor is blocked.
▷ Open the door of the milling machine.
▷ Press service button [B] on the milling machine.
The sealing air is activated. The service button
lights up.
After the maintenance
When the maintenance is completed:
▷ Shut the door of the milling machine.
▷ Briefly press operation button [A].
The tool is picked up again. The spindle travels
back to the starting position or to the position,
where the program was interrupted.
C L E A N I N G A N D M A I N T E N A N C E
Spindle
The provided Jäger spindle service set and a mill-
ing tool of your choice are required for mainte-
nance of the spindle.
5
4
Fig. 21 Service set for Jäger spindle
1 Collet grease
2 Collet brush
3 Felt cone
4 Ejector pin
5 Spindle wrench
In order to clean the spindle:
▷ Remove any dust from the cap, the C/L pipes
and the spindle using a dry, soft cloth. Do not
use cleaning agents!
To remove the collet:
▷ Apply the black spindle wrench [5] over the col-
let.
Fig. 22
▷ Insert a milling tool into the open collet.
1
2
3
5
63
E N