IDC Mill 5X Mode D'emploi page 53

6.1 Switching between wet and dry processing
The milling machine can be used both for wet and
dry processing.
6.1.1 Switching from dry to wet processing
1
Fig. 13
1 Extraction hood
2 Lever
3 Swarf sieve
4 Splash guard
5 Extraction hood
B Service button
▷ Disengage lever [2] and pull off the white
extraction hood [1] toward the front.
▷ Connect the extraction hose to the extraction
opening in the milling chamber.
▷ With the door open, briefly press service button
[B] on the front side of the milling machine.
The extraction starts.
▷ Vacuum out the milling chamber.
A P P L I C A T I O N A N D O P E R A T I O N
2
B
In delivery condition, it is set up for dry process-
ing.
4
When the milling chamber is clean:
▷ Press service button [B] again.
The extraction stops.
▷ Pull off the extraction hose.
▷ Insert the cleaned swarf sieve [3].
The wide side faces toward the rear.
For wet processing, it is mandatory to use
the swarf sieve [3]. The sieve serves as the
first coolant/lubricant stage for coarse
particles.
▷ Check if the outlet holes of the C/L nozzles are
unobstructed.
▷ Check if the door gasket is clean and free of
swarf/chips.
5
3
53
E N