Grsb And Grsbf Models - Hatco Glo-Ray GPS Série Manuel D'installation Et D'utilisation

INSTALLATION

GRSB and GRSBF Models

1. Remove the unit from the carton and place it upside down
on the cardboard.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
Underside of GRSB Models
2. Remove and save the bracket screws from the underside
of the unit.
NOTE: The control box may be moved to the most convenient
location on the underside of the unit. For semi-remote
installations, leave the control box in place until the unit
is placed into the countertop.
NOTICE
Unit is designed and recommended for use in or on
metallic countertops. Damage to any countertop material
is not covered under the Hatco warranty. For other
surfaces, verify with manufacturer that material is suitable
for prolonged temperatures up to 200°F (93°C).
3. Prepare countertop opening. Refer to the appropriate
"Countertop Cutout" chart on the following pages for
recommended countertop cutout dimensions.
4. Apply a bead of NSF-approved sealant between the
countertop material and the mounting flange on the
unit. The sealant must be rated for use at a minimum
temperature of 250°F (121°C).
5. Place the unit into the countertop opening.
6. Assemble the Z-brackets to the underside of the unit using
the four bracket screws removed earlier in this procedure
(refer to the illustrations on the following pages).
NOTE: Units 60" (1524 mm) or longer require two additional
Z-brackets to be installed midway along the front and
rear of the unit.
7. Adjust the mounting screws on the Z-brackets until the top
flange lies flat on the countertop.
NOTICE
Do not use excessive force when tightening mounting
screws on built-in units. This may damage unit and/or
countertop.
Bracket Screw
8. Remove any excess sealant.
9. If desired or necessary, the control box can be mounted in
a semi-remote location.
a. Remove the control box from the bottom of the unit.
b. If necessary, remove the end brackets from the control
box, rotate/reposition, and re-secure to the control box.
c. The control box can be panel, surface, under counter, or
recess mounted.
Panel
2-1/8"
(54 mm)
Control Box Mounting Options
d. The distance the control box can be mounted from the
unit is determined by the 36" (914 mm) conduit. Do not
pull the conduit tight to increase the mounting distance.
The conduit should have some slack after the control
box is mounted.
Do not modify wiring or cut thermostat capillary on control
enclosure to increase-remote mounting distance. Cutting
thermostat capillary will cause unit to overheat and may
damage unit as well as surrounding countertop.
10. Once all components are secured, proceed to the
OPERATION section.
NOTE: A 6' (1829 mm) cord is supplied with this unit; any
excess cord should be routed neatly so it does not
hang down.
14
English
Under Counter
Surface
7-1/4"
(184 mm)
7"
(178 mm)
2"
(51 mm)
NOTICE
Form No. GRSM-0318