Environment; General Information - Festool TPC 18/4 Notice D'utilisation

can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
To open the Systainer
Turn the T-loc [SYS-b-1] to this posi­
tion.
To lock the Systainer
Turn the T-loc [SYS-b-1] to this posi­
tion.
To connect two Systainers
Place one Systainer on the top of the other
(Fig. [SYS-a]).
Turn the T-loc [SYS-b-1] to one of
this positions (Fig. [SYS-b]).
The Systainers are connected and locked.
A Systainer Classic Line can be connected
to a Systainer T-Loc or to a Systainer
from below via its four locking devices.
A Systainer T-Loc can be connected to a
Systainer 3 both from below and from
above.
3
SYS-b-1

15 Environment

Do not dispose of the device together with do­
SYS-a
mestic waste! Dispose of machines, accesso­
ries and packaging at an environmentally re­
sponsible recycling centre. Observe the valid
national regulations.
Battery Disposal
Risk of fire or injury
► Do not attempt to disassemble the battery
or remove any component projecting from
the battery terminals.
► Prior to disposal, protect exposed termi­
nals with heavy insulating tape to prevent
shorting.

16 General information

16.1 Information on data privacy
The power tool contains a chip which automati­
cally stores machine and operating data. The
data saved cannot be traced back directly to an
individual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en­
hancement of the power tool. The data shall not
be used in any other way without the express
consent of the customer.
SYS-b
WARNING
English
17