Table des Matières
Publicité
REAR SHOCK ABSORBER REBOUND DAMPING
FORCE ADJUSTMENT
5. Tighten:
9 Locknut
6. Install:
9 Rear frame (upper)
9 Rear frame (lower)
EC36N014
REAR SHOCK ABSORBER REBOUND
DAMPING FORCE ADJUSTMENT
1. Adjust:
9 Rebound damping force
By turning the adjuster 1.
Stiffer a a ¡
Softer b b ¡
Extent of adjustment:
Maximum
Fully turned in
position
9 STANDARD POSITION:
This is the position which is back by the specif-
ic number of clicks from the fully turned-in posi-
tion. (Which align the punch mark a on the ad-
juster with the punch mark b on the bracket.)
Standard position:
About 10 clicks out
cC
Do not force the adjuster past the minimum
or maximum extent of adjustment. The ad-
juster may be damaged.
3-31
INSP
ADJ
32 Nm (3.2 m•kg, 23 ft•lb)
29 Nm (2.9 m•kg, 21 ft•lb)
Increase the rebound damping
force. (Turn the adjuster 1 1 in.)
Decrease
the
damping force. (Turn the ad-
juster 1 1 out.)
Minimum
20 clicks out
(from maximum
position)
rebound
Publicité
Table des Matières
