Firewood; Drying And Storing - RAIS X-Basic Manuel D'utilisation

US English User Manual RAIS X-Basic, RAIS X-Front & RAIS X-Board

Firewood

Only burn wood that has been seasoned for at least one full year (two years is better). If
the wood has not been seasoned or dried, energy will be lost in evaporating the water
held in the wood. Furthermore, condensation or creosote might occur in the stove and
pipe when damp wood is burnt.
Freshly cut wood contains approx. 60-70% water and is completely unsuited for burning.
Log size should be about 2" (5 cm) less than the width of the firebox
never
burn trash
),
harmful gases
-
non seasoned wood
All types of wood heat equally per pound; however, the density of wood is not the same
as is shown in the table below, where the combustible value of wood dried for two years
with a moisture of 15-20% is taken into account. See table to the left.
Drying and storage
Wood to be used for burning in a stove should be dried for two years to ensure optimal
burning.
Here are some storage tips:
• Cut and split the wood before storing.
• Keep the woodpile in a dry sunny place, protected from the rain. Do not cover the pile
with plastic, because that prevents the wood from drying properly.
• Stack the wood with enough space between the rows to ensure good air circulation.
• Bring the logs inside the house two-three days prior to use.
Wood type
Beech and oak
Ash
Maple
Birch
Mountain pine
Fir
Poplar
(
plastIc and other types of artIfIcIal materIals emIt
,
drIftwood treated or paInted wood
.
Dry wood In comparison
kg/m³ to beech
580 100 %
570 98 %
540 93 %
510 88 %
480 83 %
390 67 %
380 65 %
,
artIfIcIal logs or
d
o not store solId fuel wIthIn
space heater InstallatIon
clearances or wIthIn the space
requIred for chargIng and
.
ash removal
35