RAIS X-Basic Manuel D'utilisation page 25

US English User Manual RAIS X-Basic, RAIS X-Front & RAIS X-Board
2. Fasten the reflector plate by the two flat allen screws in
the upper middle of the stone front.
3. Then fasten the steel frame with 4 allen screws. Be very
careful to install two washers are placed at each allen screw
between the stone front plate and the steel frame. This is
required so the reflector plate can expand without resis-
tance.
4. Install the two angle braces on the stone front. As for
item 3 be careful to install two washers for each allen
screw.
5. Put one cork pad on left and right side of the bottom
side of the stone front to protect the floor.
6. Install the stainless steel handle for air control with two
fitted bolts. Then it is possible to install the spring from
underneath. The two fitted bolts should only be tightened
so it is possible to pull the handle and the spring can pull
it pack to its original position. Use the two nuts as counter-
nuts to keep the fitted bolts in this position.
7. Place the stone front in front of the stove body. Make
sure that the front is place exactly in front of the stove door.
8. Fasten the stone front using the angle braces, bolts and
nuts.
Check that it is possible to open the stove normally as well
as tilting the door for cleaning acc to instructions
25