RAIS X-Basic Manuel D'utilisation page 16

US English User Manual RAIS X-Basic, RAIS X-Front & RAIS X-Board
16. Alignment of front panel – INFO: The front and side panels is aligned from factory. In
case that installation or transport have changed the alignment, the following adjustments
can be made:
a. The aft screw in front and side panels to be
adjusted.
b. First align the front. The door to be closed but
the door blocking handle to be in open position.
The clearance around the stove door to equal.
The air control handle to be possible to move from
one side to the other without touching the front
panel.
c. Check that it is
possible to open
the stove nor-
mally as well as
tilting the door
for cleaning acc
to instructions
before putting
on the side pan-
els.
17. Install the side panels using gloves
18. If necessary align the side panels according to the front panel. Distances front/side
panels to be 5 mm.
19. Install the back side panel using gloves
a. The upper nuts and springs to be installed.
b. The lower screws to be installed.
20. If necessary align the back side panel according to the side panels. Distances side/back
side panels to be 5 mm.
16