Installing The Batteries - Spektrum PowerSafe AR9110 Manuel D'instructions

EN
Installing the PowerSafe Main Unit
1. Using foam or thick double-sided foam tape and tie wraps, secure the main
PowerSafe unit in the position that you would normally mount the receiver.
2. Mount the switch on the side of your aircraft and insert the switch plug
in the port in the main unit marked SWITCH.
Note: The PowerSafe uses a specifically designed switch.
Conventionally wired switches are not compatible with the SmartSafe.

Installing the Batteries

Using the above guidelines select the battery system that best fits your
application and install the battery(s)/regulator(s) in your aircraft. Connect
the battery to the PowerSafe. Spektrum batteries are pre-wired with an EC3
connector and plug directly in. If using another brand of battery it will be
necessary to solder EC3 connectors (two are included with the AR9110)
to the battery leads. If using a regulator, install it per the guidelines
included with the regulator.
12