Publicité
Les langues disponibles
Les langues disponibles
robert
juliat
Read user's instructions before using this lighting unit.
Besides these instructions indicated on this page, you must respect the relevant safety and
health related requirements of the appropriate EU Directives.
This unit enters section 17: Lighting appliance for theatre stages, television, cinema and
photograph studios. Standards applied: NF EN 60598-1 and NF EN 60598-2-17.
This unit is considered as IP20, reserved for indoor use only.
•
Disconnect from the mains before any servicing. Warning, high voltage ignition.
•
The protection screens, lenses or U.V. filters must be replaced if there is any visual damage to
a point where their performances are reduced, for example, by cracks or deep scratches.
•
The bulb must be replaced if it has been damaged or deformed by the heat.
•
Do not use a bulb with a power or type which is different to that indicated. Check that the bulbs
voltage corresponds to the mains voltage used.
•
Make sure the unit is correctly mounted on an appropriate support (tripod or hook).
•
In a hanging position (hook, bolt...), the safety requirement of the unit must be assured by an
other hanging accessory (security cable, chain...) with a suitable length and correctly attached
at the back of the unit. This must be mounted as short as possible or rolled up a few times if needed.
•
The movable accessories (barn doors, spill rings...) must also be safety assured with a suitable
security cable hooked onto the front of the unit. Take into account the weight, for a correct
attachment of the security cable.
Do not open the lighting unit, when the bulb is on.
•
U.V. rays: Protect your eyes.
•
Bulb and holder hot: wait until the unit is cold, before servicing.
•
Do not tamper with the security layout.
•
Tighten regularly the connections. Replace the cable with an identical one, if damaged.
•
Check the distance from any flammable material.
•
Do not expose to bad weather. Do not cover.
•
Use only when bulb is in place.
•
If the lighting unit has any fans, make sure they are working correctly. If any are not working,
•
turn the unit off immediately and effectuate the necessary servicing.
Clean frequently the filters, if there are any.
•
Don't obstruct the air gaps.
•
Keep optical parts clean.
•
These products have been built to conformity with European standards that concern
•
professional lighting equipment. Any modifications made to our products, will cease the
manufacturers liability.
•
Professional material: Service only by qualified technician.
3
robert juliat
TECHNICAL FILE
575W HMI FOLLOWSPOT
1 0 1 0
A DATER DU:
VALID SINCE :
Thank you for your attention.
ROUTE DE BEAUMONT F 60530 FRESNOY - EN - THELLE
TEL.: 33 (0)3.44.26.51.89
FAX : 33 (0)3.44.26.90.79
12.06.98
Publicité
