CONNECTIONS.
(*) WARNING !
- Breaker 2 controls the lamp cooling fan and must be
engaged to avoid the activation of the thermal safety cut.
- Stick the red label (DE40976100 enclosed with this
tech. file) onto the PSU, just below the Aux. breaker 2 .
Mains voltage.
- Check the conformity of the power supply unit.
Rating plate 7 : Lamp power.
Lighting unit / Power supply connection.
- Connect the lamp cable C to the connector 5 of the ballast.
- Place the lamp into position.
- Engage the circuit breaker 3 and check that the protection
4 is well engaged.
- Plug the cable 6 to the mains. The checklight 1 lights up
immediately.
- Engage the automatic breaker 2 .
WARNING !
- Never open the accessory cassette when the lighting unit is on.
- Never connect to a dimmable channel.
- Use only when lamp in place.
- The spotlight goes into safety mode when the surrounding
temperature is higher than 40°C.
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: +33 (0)3.44.26.51.89 - fax: +33 (0)3.44.26.90.79 - www.robertjuliat.fr
TECHNICAL FILE
MSR 2500W G38 SPOTLIGHT
A
C
Spotlight.
B
4
1 2 3
5
7
6
DESCRIPTION.
A MSR 2500W G38 Spotlight.
B Power supply unit with manual control unit
(refer to the P.S.U. technical file).
C Lamp cable.
Cable H07 RN-F 18G1,5 mm
with 16 x 16A M HARTING connector.
326LFV
Section - 4
Power supply unit (P.S.U.)
with manual control unit
2
length 3m fitted