Publicité
Les langues disponibles
Les langues disponibles
robert
juliat
HOW TO ADJUST THE MAINS POWER INPUT.
Make sure the unit is disconnected from the mains.
- Place the lighting unit on it's back.
Yoke positioned towards the front of the zoom.
- Remove the cover 1 of the lantern A .
- Remove also the 6 screws 2 .
- Then slide the cover 3 towards and disconnect the earth wire 4 .
- Now you can acceed to the choke's terminal 5 .
- Do not remove the wires connected to the "0" position.
- Place the ring tongue terminal 6 on the voltage required.
- Make sure that all the nuts 7 are well tighten by using two 8 size spanners
for the M5 nuts.
- Display the correct voltage plate 8 , that has been connected.
110V - 60Hz Version : Use a separate 1200W. transformater (for 1 or 2 Follow spots).
11
robert juliat
TECHNICAL FILE
575W HMI FOLLOWSPOT
5
0 -
208V 60Hz -
230V 50Hz -
245V 50Hz -
6
7
208V 60Hz
245V 50Hz
220/240V 50Hz
8
DETAIL "C"
1 0 1 0
A DATER DU:
VALID SINCE :
DETAIL "B"
DETAIL "C"
2
4
A
DETAIL "B"
ROUTE DE BEAUMONT F 60530 FRESNOY - EN - THELLE
TEL.: 33 (0)3.44.26.51.89
FAX : 33 (0)3.44.26.90.79
12.06.98
3
1
Publicité
