Powering And Managing The Unit - Olimpia splendid MAESTR SMART Directives D'installation, D'utilisation Et D'entretien

DISPLAY
D1 fan speed or automatic operating mode
indicator (aUto)
D2 Heating
D3 Cooling
D4 Dehumidification only
D5 air change activation
(not available in this model)
D6 night operation switch
D7
automatic operation switch
D8
first operating program switch
D9
Second operating program switch
D10 temperature indicator (thermometer) or time
indicator (H/m)
D11 Desired temperature/clock/programming
D12 fan speed
D13 transmission of the command in progress
D14 Program switching off time setting
D15 Clock/program setting
D16 Program switching on time setting
D17 Low battery notification
D18 minutes timer
3.3.3 - POWERING AND MANAGING THE UNIT (fig.34)
To operate the unit using the remote control it will be necessary to energize the main switch on the electrical
power supply line or by inserting the unit's plug into the appropriate wall outlet.
• The unit is fitted with a power switch (10) located below the lower safety guard (9).
• To run this power switch must be in "I" position.
• At this point the unit can be operated by the remote control. In order to transmit commands to the indoor
unit, point the front of the remote control toward the unit's control panel.
• The device emits a beep when it receives a command.
• The remote requires direct line of sight with the unit's receiver with a maximum distance between them
being 8 m/26 feet.
D2
D1 D3
D7
D8
D9
D4
D3 D13
D2
D11
D6
D12
D4 D6
D5
D10
E
D7 D14
D8 D15
D9
D16
D10
D17
D18
D1 F
USA - 17
MAESTRO SMART