Rear Squeegee Rubber Replacement; Squeegee Hose Cleaning; Cleaning Of Solution Tank And Filter; Front Squeegee Rubber Replacement - ADIATEK ruby 50e Emploi Et Entretien

GB

REAR SQUEEGEE RUBBER REPLACEMENT

Check the squeegee rubber wear and eventually turn
or replace it.
For the replacement it is necessary to:
1. Lift the squeegee acting upon the lever (8).
2. Uncouple the hook (1) of the rubber holder blade,
release the extremities (2) from the squeegee body
and take off the rubber (4).
3. Turn the rubber (4) to a new side or replace it.
To reassemble the squeegee repeat reverse the op-
erations above-mentioned, inserting the rubber (4)
on the guides (3), couple the extremities (2) of the
rubber holder blade onto the squeegee body and fi-
nally block the hook (1).

SQUEEGEE HOSE CLEANING

Weekly or in case of insufficient suction, it is neces-
sary to check that the squeegee hose is not ob-
structed. Eventually, to clean it, proceed as follows:
1. Take off the hose from the squeegee coupling (A)
and release the guide spring of the squeegee hose
(25).
2. Wash the inside of the hose with a water jet,
from the squeegee hose side.
3. To reassemble the hose repeat reverse the opera-
tions above-mentioned.

CLEANING OF SOLUTION TANK AND FILTER

1. Bring the machine to an appropriate place for
tanks draining.
2. Unscrew the solution tank cap (13).
3. Close the solution valve (9).
4. Unscrew the exhaust plug (A).
5. Open the solution valve (9).
6. Rinse with a water jet the solution tank.
7. Rinse the solution tank filter placed inside the
exhaust plug, under the machine.
8. Reassemble all parts.
ATTENTION:
This operation must be carried out using gloves to
protect from contact with dangerous solutions.

FRONT SQUEEGEE RUBBER REPLACEMENT

Check the wear of the squeegee rubber and eventu-
ally replace it.
For the replacement it is necessary to:
1. Take off the squeegee hose (A) from its coupling.
2. Disassemble the squeegee from the support ro-
tating the lever (B) counterclockwise and sliding the
stud bolts (C) in their slots.
20
3. Uncouple the hook (1) of the rubber holder blade,
release the extremities (2) from the squeegee body
and take off the rubber (4).
4. Unscrew the wing nuts (5) in the upper part of
the squeegee.
5. Slip off the lower part (6) of the squeegee body,
so to take off the front rubber (7).
6. Replace the front rubber.
7. To reassemble the squeegee repeat reverse the
operations above-mentioned.

SPLASH GUARD REPLACEMENT

1. Unscrew the knobs in the rear part of the brush
base group from the extremity of the metal strips.
The operation has to be carried out on both splash
guards.
2. Unscrew the nut on the front part of the brush
base group and take off the metal strips.
3. Replace the splash guard rubbers and follow the
assembling instructions at "SPLASH GUARD ASSEM-
BLY" paragraph.
With the brush assembled, the splash guard must
slightly touch the floor.
GB