GB
STOP
Releasing the lever of the presence (1), the brush ro-
tation will end, stopping the machine movement.
ATTENTION:
Whenever moving the machine backwards, make
sure that the squeegee is lifted.
STOP
OF
THE
MACHINE
CLEANING OPERATION
Before executing any type of maintenance:
1. Switch off the general switch (1).
2. Lift the squeegee acting upon the lever (2).
3. Rotate backwards the machine so to lift the
brush base. With the right balance on the wheels,
bring the machine to an appropriate place for tanks
draining.
ATTENTION:
The machine is not equipped with a parking brake,
therefore do not leave it on slopes.
MAINTENANCE
RECOVERY TANK CLEANING
1. Hold the exhaust hose placed in the front part of
the machine.
2. Take off the exhaust plug acting upon its lever
and empty the recovery tank into appropriate con-
tainers (see under "OVERFLOW DEVICE").
3. Take off the suction cover (17) after rotating the
blocking levers (A).
4. Take off the filter and filter protection.
5. Rinse the tank with a water jet.
ATTENTION:
This operation must be carried out using gloves to
protect from contact with dangerous solutions.
SUCTION FILTER CLEANING
1. Take off the suction cover (17) after rotating the
blocking levers (A).
AFTER
2. Take off the filter and filter protection.
3. Clean all parts with a water jet especially inside
surfaces and filter bottom.
4. Carry out carefully the cleaning operations.
5. Reassemble all parts.
BRUSH CLEANING
Disassemble the brush and clean it with a water jet
(for the brush disassembly, check "BRUSH DISAS-
SEMBLY" paragraph).
BRUSH DISASSEMBLY
1. Take off the electric supply to the brush motor
unplugging the batteries connector (1).
2. Take off the squeegee.
3. Lift the support raising the lever.
4. Rotate backwards the machine until it rests on
the support wheels, so to lift the brush base.
5. With the brush base in lifted position, rotate the
brush energically, until the button is released from
the coupling spring and the brush comes off.
The figure shows the rotating sense for brush release.
22
ATTENTION:
The execution of brushes disassembly operations
with electric supply on, may cause damages to hands.
SQUEEGEE CLEANING
Keeping the squeegee clean guarantees always the
best drying action.
For the cleaning it is necessary to:
1. Take off the squeegee hose (A) from the coupling.
2. Disassemble the squeegee from the support ro-
tating the lever (B) counterclockwise and sliding the
stud bolts (C) in their slots.
3. Clean with care the internal part of the squeegee
inlet eliminating eventual dirt residuals.
4. Clean with care the squeegee rubbers.
5. Reassemble all parts.
REAR SQUEEGEE RUBBER REPLACEMENT
Check the squeegee rubber wear and eventually turn
or replace it.
For the replacement it is necessary to:
1. Lift the squeegee acting upon the lever (8).
2. Uncouple the hook (1) of the rubber holder blade,
release the extremities (2) from the squeegee body
and take off the rubber (4).
3. Turn the rubber (4) to a new side or replace it.
To reassemble the squeegee repeat reverse the op-
erations above-mentioned, inserting the rubber (4)
on the guides (3), couple the extremities (2) of the
rubber holder blade onto the squeegee body and fi-
nally block the hook (1).
GB