Select The Input Source To Be Projected; Adjust The Screen Size (Zooming) - JVC DLA-M2000LU Manuel D'instructions

(QJB%RG\IP 3DJH  7XHVGD\ 2FWREHU     30
Basic Operations
I Projector's buttons
STAND BY
LAMP TEMP
OPERATE
HIDE
PC
KEYSTONE VOLUME
VIDEO
PRESET MENU
ESCAPE ENTER
I Remote control unit
FREEZE OPERATE
HIDE
PRESET MENU
ESCAPE VIC SELECT
PC
+
DIGITAL
ZOOM KEYSTONE VIDEO
–
+
U T
SHIFT ZOOM FOCUS
–
D W
+ +
QUICK
SHUTTER ALIGN. VOLUME
– –
RM-M2000 REMOTE CONTROL UNIT
I Language display
The display languages of the menus, direct buttons
(DIGITAL ZOOM, KEYSTONE, VOLUME, etc) and
messages is set to "ENGLISH" when the projector is bought.
The display language can be selected from the following 6
languages: " (Japanese)", "English (English)",
"Deutsch (German)", "Español (Spanish)", "Italiano (Italian)"
and "Français (French)". (Refer to page 45.) However, some
words (VIDEO, NTSC, Quick Alignment, etc) are only
displayed in English.
32
PC button
VIDEO button
PC button
VIDEO button
ZOOM button
DLA-M2000LU/M2000SCU/ LCT0940-002B / ENGLISH

2. Select the Input source to be Projected

Press the VIDEO button or the PC button to switch the
input.
• Each time you press either button, the selected input
changes as follows. The selected name appears on the top
right of the image on the screen for five seconds. (Called
line display.)
When you press the VIDEO button:
Y/C l VIDEO
When you press the PC button:
PC1 l PC2
Remote control unit
PC
VIDEO
[Screen display]
VIDEO
Q U I C K A L I G N M E N T
* To show the line display (Y/C, VIDEO, PC1, or PC2) or not
is selectable by the menu. Refer to "Setting and Adjusting
Other Functions (OPTIONS)" on page 52.
Notes
• When the AV IN (Y/C or VIDEO input) terminal input signal
source is switched with the VIDEO button, it is necessary to
reconnect the audio cable to the active device since the
projector has only a single AUDIO input terminal.
• When the PC1 or PC2 input terminal signal source is
switched with the PC button, it is necessary to reconnect
the audio cable to the active device since the projector has
only a single PC AUDIO input terminal.
• When no image signal is input to the selected input
terminal, the message "No Input" is displayed on the
screen. (Refer to page 64.)
• When the PC2 input terminal is used, "PC2 (BNC)" must be
selected from the menu options. (Refer to page 52.)

3. Adjust the Screen Size (Zooming)

How to adjust the projected screen size differs depending on
the lens unit (optional) you are using.
GL-M2910G (without zooming function):
The projected screen size cannot be changed.
GL-M2915SG/GL-M2920ZG/GL-M2930SZG (with
zooming function):
Adjust the projected screen size with the following buttons on
the remote control unit.
Projector
PC
VIDEO
Line Display
PC 1
PC 2
Y/C
VIDEO