JVC DLA-M2000LU Manuel D'instructions page 12

(QJB'/$0ERRN 3DJH  7KXUVGD\ $XJXVW     $0
Controls and Features
9
ESCAPE button
This button will be used in the menu mode to return to the
previous menu. When the main menu is displayed, this
button will cause the menu to disappear. For details, refer
to "Basic Menu Operation" on page 42.
p
PRESET button
This PRESET button only works as a reset button for the
direct button adjustment of the VOLUME button and
KEYSTONE button of the control panel and the VOLUME
button and DIGITAL ZOOM button of the remote control.
When adjusting the volume, keystone or digital zoom
(when the setting is displayed on the screen) the
adjusted value is reset to that which was set when the
projector was shipped from the factory. Of the menu
items, this button only works for the keystone setting
screen.
q
KEYSTONE / buttons
Use these buttons to correct a trapezoidal distortion of
the projected image. (Refer to page 34.)
w
HIDE button
Use this button to turn off the image on the screen and
audio sound temporarily. Pressing it again restores the
image and audio sound to resume. (Refer to page 34.)
e
VOLUME +/– buttons
Use these buttons to adjust the sound volume:
+ : Increase the volume level. (0 → 50)
– : Decrease the volume level. (50 → 0)
(Refer to page 33.)
r
LAMP indicator
ON : After the light-source lamp has been used for
more than approx. 900 hours.
Blinking : After the light-source lamp has been used for
more than approx. 1000 hours. Replace the light-
source lamp. Refer to "Replacing the Light-
Source Lamp" on page 56.
t
TEMP indicator
Blinking : The temperature inside the projector has risen
abnormally.
Note
• While the TEMP indicator is blinking (during abnormal
temperature), the power is automatically cut off.
10
DLA-M2000LU/M2000SCU/ LCT0940-002A / ENGLISH