Antari SNOW MACHINE S-100II Mode D'emploi page 8

to each device, they require addressing. This is to be adjusted for every single device
by changing the DIP-switches as set out in the table below.
The starting address is defined as the first channel from which the device will respond to
the controller. Please make sure that you do not have any overlapping channels in order
to control each device correctly and independently from any other fixture on the DMX
data link. If two, three or more devices are addressed similarly, they will work similarly.
Occupation of the DIP-switches
Setting the
DIP-Switch
DMX-Starting
NO.
Address
Device
Starting
Number &
Address
Channels
Device 1–Channel 1
Device 2–Channel 2
Device 3–Channel 3
Device 4–Channel 4
Device 5–Channel 5
Maintenance
1. Do not allow the snow liquid to become contaminated. Always replace the caps on the
liquid container and the snow machine liquid tank immediately after filling.
2. Before storing away after each operation, rinse the system with pure water and let it pump
for at least 1or 2 minutes. This step helps to ensure a longer life-span of the motor and the
nozzle.
3. It is strongly recommended to regularly clean the dust/residue around snow machines'
vent holes (on both sides of the machine). Simply use a small brush, a toothbrush for
example, and gently brush in the direction from top to bottom. This step helps to ensure
that minimal debris will get into the machine or causes clogging.
1 2
1 2
▲
ON
▽
OFF
▲
ON
▽
OFF
▲ ▲
ON
OFF
ON
▽ ▽
OFF
▲
ON
▽
OFF
3 4 5
4 8 16
▽ ▽ ▽
▽ ▽ ▽
▽ ▽ ▽
▲
▽ ▽
▲
▽ ▽
8
6 7 8
32 64 128 256
▽ ▽ ▽
▽ ▽ ▽
▽ ▽ ▽
▽ ▽ ▽
▽ ▽ ▽
9
▽
▽
▽
▽
▽