Daily Use; Activating And Deactivating; Bridge Function - Progress PAI6140A Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8 Progress

DAILY USE

WARNING! Refer to Safety
chapters.

Activating and deactivating

Touch
for 1 second to activate or
deactivate the hob.
Automatic Switch Off
The function deactivates the hob
automatically if:
• all cooking zones are deactivated,
• you do not set the heat setting after you
activate the hob,
• you spill something or put something on
the control panel for more than 10
seconds (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or clean
the control panel.
• the hob gets too hot (e.g. when a
saucepan boils dry). Let the cooking
zone cool down before you use the hob
again.
• you use incorrect cookware. The symbol
comes on and the cooking zone
deactivates automatically after 2
minutes.
• you do not deactivate a cooking zone or
change the heat setting. After some time
comes on and the hob deactivates.
The relation between the heat setting
and the time after which the hob
deactivates:
Heat setting
, 1 - 2
3 - 4
5
6 - 9
The heat setting
To set or change the heat setting:
The hob deacti-
vates after
6 hours
5 hours
4 hours
1.5 hour
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct heat
setting.
Using the cooking zones
Put the cookware on the cross / square
which is on the surface that you cook.
Cover the cross / square fully. Induction
cooking zones adapt to the dimension of
the bottom of the cookware automatically.
You can cook with the large cookware on
two cooking zones at the same time.

Bridge function

The function operates when the
pot covers the centres of the
two zones.
This function connects two cooking zones
and they operate as one.
First set the heat setting for one of the
cooking zones.
To activate the function for left / right
cooking zones: touch
change the heat setting touch one of the
left / right control sensors.
To deactivate the function: touch
. The cooking zones operate
independently.
When you use only one cooking zone of the
pair we recommend that you use the rear
cooking zone. Also when you use large
cookware we recommend that you put it
near to the rear cooking zone.
Automatic Heat Up
Activate this function to get a desired heat
setting in a shorter time. When it is on, the
/
. To set or
/

Publicité

Table des Matières
loading

Table des Matières