Accessing The Utility; Figure 6-1: Password Screen - Cisco Systems LINKSYS WAP54G Guide D'installation Rapide

Wireless-G Access Point

Accessing the Utility

To access the Web-based Utility of the Access Point, launch Internet Explorer or Netscape Navigator, and enter
the Access Point's default IP address, 192.168.1.245, in the Address field. Press the Enter key.
Open your web browser and type the IP Address you entered in the Setup Wizard. (The default IP address is
192.168.1.245.) (Should you need to learn what IP Address the Access Point presently uses, run the Setup Wizard
again. It will scan the Access Point and give you its IP Address.) Press the Enter key and the following screen will
appear. Leave the User Name field blank. The first time you open the Web-Based Utility, use the default password
admin. You can set a new password from the Password tab.
Chapter 6: Configuring the Wireless-G Access Point
Accessing the Utility

Figure 6-1: Password Screen

static ip address: a fixed address assigned to
a computer or device connected to a network
16