Cisco Systems LINKSYS WAP54G Guide D'installation Rapide page 3

2
Configuring the Access Point
The Access Point should be config-
NOTE:
ured through the Setup Wizard and set up
through a wired network connection.
Now that you've connected the
Access Point to your wired network,
you are ready to begin setting it up.
This Setup Wizard will take you
through all the steps necessary to
configure the Access Point.
A
Insert the Setup Wizard CD into
your PC's CD-ROM drive. Your
PC must be on your wired net-
work to set up the Access Point.
B
The Setup Wizard's Welcome
screen should appear on your
monitor. If it does not, this
means the Setup Wizard is not
automatically running as it
should. Start the Setup Wizard
manually by clicking the Start
button, selecting Run, and typ-
ing d:\setup.exe (where "D" is
your PC's CD-ROM drive). Click
the Setup button to continue
this Setup Wizard. Click the User
Guide button to view the User
Guide. To exit this Setup Wizard,
click the Exit button.
B
3