Glass / Door Replacement; Care Of Glass; Care Of Plated Parts - Napoleon HDX35NT Instructions D'installation Et D'opération

Masquer les pouces Voir aussi pour HDX35NT:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

52

10.8 GLASS / DOOR REPLACEMENT

EN
CARE MUST BE TAKEN WHEN REMOVING AND DISPOSING OF ANY BROKEN DOOR GLASS OR
DAMAGED COMPONENTS. BE SURE TO VACUUM UP ANY BROKEN GLASS FROM INSIDE THE
DO NOT STRIKE, SLAM OR SCRATCH GLASS. DO NOT OPERATE APPLIANCE WITH GLASS
A.
Place the door frame face down careful not to
scratch the paint.
B.
Ensure the glass retainers are bent up prior to
replacing the glass and gasket.
C.
Center the gasketed glass inside the door
frame with the thick side of the gasket
facing up.
D.
Bend the glass retainers located along the edge
of the door frame over the gasket holding the
glass in place. Be careful not to break the glass.

10.9 CARE OF GLASS

DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the fi rst 10 hours of operation with a
recommended fi replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
This appliance is factory equipped with 5mm ceramic glass. Use only replacement glass available from your
Napoleon dealer. DO NOT SUBSTITUTE MATERIALS.
10.10

CARE OF PLATED PARTS

If the appliance is equipped with plated parts, you must clean fi ngerprints or other marks from the plated
surfaces before operating the appliance for the fi rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the fi rst time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the fi ngerprints and oils will not affect the fi nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat
source.
W415-1434 / 06.09.15
!
DO NOT USE SUBSTITUTE MATERIALS.
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
APPLIANCE BEFORE OPERATION.
REMOVED, CRACKED, BROKEN OR SCRATCHED.
WARNING
GASKET
DOOR
FRAME
56.2
GLASS
RETAINERS
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
5.1
5.5.1
6.1
GLASS

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Hdx35ptHdx52pt-2

Table des Matières