Lateral Trunk Supports (Advanced); Q.lateral Trunk & Head Supports (Moderate) - Zippie VOYAGE Manuel D'instructions

Z I PP I E VO YA GE
P. LATERAL TRUNK SUPPORTS (ADVANCED)
Assembly to the Seating Shell
a. From behind your unit, unzip the back upholstery and remove the back pad to expose
back shell.
b. Insert screws and washers (A) from the rear of the shell through the adjustment slots.
c. Thread the bolts into the lateral nut plate clamping the lateral mounting plate to the
backshell.
d. Tighten the screws.
Lateral Height and Width Adjustments
NOTE - The following adjustments may be able to be accomplished with the child present in the seating
system.
a. Unzip the rear cover to access the adjustment screws.
b. Loosen (do not remove) the mounting screws (B) from the front of the shell enough
to gain horizontal adjustment of the laterals. Adjust the lateral brackets for width
bringing the lateral assembly including the pads to the proper position. If more hori-
zontal adjustment is needed, you can also adjust the swing-away bracket.
c. Tighten the mounting screws to hold the adjustment.
d. To gain vertical adjustment of the laterals, loosen screws (A) from the rear of the back-
shell, and move the laterals up or down to the proper position, and tighten the screws.
Lateral Length and Rotation Adjustments
a. Slide the lateral cover and foam forward or remove to expose adjustment screws.
b. Loosen screws (D) and move lateral to proper length, you can also add a slight
rota-tion by twisting the lateral slightly. Be sure to make the same adjustment on
the other side.
c. Tighten screws and replace the foam and cover.
Lateral Swing-Away Operation
a. Depress the silver lever (C) allowing the lateral to swing inwards or outwards. This is
useful for storage or helping a child into or out of the seating system.
NOTE - The laterals lock into the adjusted preset position which can be angle adjusted by following
steps in the next section "Lateral Angle Adjustment".
Lateral Angle Adjustment
a. Lock the lateral by rotating inwards.
b. Loosen the angle lock screw (E) as shown at the lateral hinge
point.
c. Adjust the lateral angle to the proper position and tighten.
Q. LATERAL TRUNK AND HEAD SUPPORTS (MODERATE)
may
This adjustment be made with the user seated in the chair.
Lateral Height and Width Adjustment
or remove if necessary,
a. Loosen,
to gain adjustment of the laterals.
Use shell slots, (outer (G) or inner (H)) for height adjustment. Move the laterals up
b.
or down to the proper position and tighten the knobs.
c.
Use lateral bracket slots ( I ) for width adjustment or move from outer to inner shell
slots. Adjust the lateral brackets for width bringing the lateral assembly to the proper
position and tighten the knobs.
MK-100377 Rev. A
52
52
53
52
53
the two knobs (F) from the rear of the shell enough
IX. DEALER SERVICE & ADJUSTMENT
54 55
24
E
F
G
H
I
53
55