Caster Wheels; G.rear Wheels; H.parking Brake Operation - Zippie VOYAGE Manuel D'instructions

Z IPP IE VO YA GE
F. CASTER WHEELS
Installing and Removing the Caster Wheels
a. Locate the caster stem guide hole location on the bottom of the Voyage frame. Line
up the caster stem (A) with the hole and insert, push until the caster stem clicks into
place. Check the secure engagment to the base by pulling on the caster wheel. If it
does not move the caster wheel has been installed properly. Repeat this procedure
for other side.
b. To remove the caster wheel, press gray button (B) and slide the caster wheel out.
10
Caster Wheel Locks
a. To lock the caster wheel, Press down on the black button (C) and hold while sliding
the gray lever (D) to the locking point. Do this with both of the front caster wheels,
and check to insure that the lock has been engaged.
b. To engage the swivel wheel, press down on the black button (C) and slide the gray
lever (D) to the right or left of the centerpoint. Repeat for the other side. Figure 9
shows the gray lever in the swivel position.
11
G. REAR WHEELS
Installing and Removing the Rear Wheels
a. To install rear wheel, gently slide the rear wheel's axle into the hole in the frame until
the wheel clicks into place.
b. To remove the rear wheel, simply press the wheel button (E) while gently sliding the
wheel away from the frame.
H. PARKING BRAKE OPERATION
Engage or Disengage the Parking Brake
a. Engage the parking brake by gently pulling the brake lever(F) into an upright position
until it clicks into place.
b. To release the parking brake, pinch the gray tabs (G) and pull up towards you. Once
released, pivot the the brake lever down until it is parallel with the frame.
9
12 13
13
VIII. USE AND MAINTENANCE
E
F
G
1MK-100377 Rev. A