APRILIA eSR1 Mode D'emploi page 21

Brake lever adjustment
eSR2 /eSR2 EVO
If the brake is too tight or too loose, adjust it by
loosening or tightening the screw (A).
If the brake lever is too soft or too hard even
after following the instructions in the first step, it
may be necessary to repeat the operation until
the optimal setting has been reached.
eSR1
A
If the brake is too tight or too loose, use the
Allen wrench to loosen the screw (A), then
adjust the brake cable, (shorten the brake cable
at the top if it is too tight; if it is too loose, pull
the brake cable downwards) and then, retighten
the screw (A).
Check the correct alignment between the brake
caliper and the disc. Use the screws (B) and (C)
to adjust the position / alignment on the disc, if
necessary.
20
C B A